Kennedy Double Edge Finder 0.500" Body in UK Specification

Kennedy Edge & Centre Finder Set (5-Pce) in UK Specification

GBP 20.18
(Indicative price - actual current price possibly lower)

Consists of a chuck body and four contact arms. Designed to check 'run-out' or concentricity, straightness and alignment. Will indicate the position of a datum point on a component or fixture from the centre line of a machine spindle. Suitable for use on drill presses, lathes, milling machines, borers etc. Chuck body: held in the spindle using a suitable drill chuck or collet chuck (fig 1). The contact arms are retained in position using the knurled collar which lightly clamps the ball joint inside the body. Arms may be exchanged without the need to remove the body from the machine spindle. Universal indicator holder the detachable end will allow clamping with 2 and 3 piece dovetail clamping assemblies and when removed will fit standard 1/4 side clamp. This uses the spindle centre line to align component bores or spigots, check the flatness or squareness of workpieces or fixturing and check run-out of components. The spindle should only be rotated manually to avoid damaging the dial test indicator (fig 1).Needle pointto lightly mark out lines and positions on a component as a guide to subsequent operations, using the machine's dials or digital read-out to position the scriber point (not illustrated). Position the contact arm in line, but slightly away from the surface to be aligned.

More Details : click here

SEARCH this site : click here

Kennedy Combination Edge/Centre Finder 0.500" Body in UK Specification

GBP 13.98
(Indicative price - actual current price possibly lower)

Cylinder typefor fast accurate work location. Made from tool steel and hardened all over, they can be used on flat surfaces, straight edges, shoulders, grooves, studs, dowels, centre points and scribed lines. UK supply of quality centre finders by Kennedy, buy online with confidence at best discount price and fast shipping. Manufacturer product ID EF/5.

More Details : click here

SEARCH this site : click here

Kennedy Edge Finder 0.375" Body in UK Specification

GBP 10.04
(Indicative price - actual current price possibly lower)

Cylinder typefor fast accurate work location. Made from tool steel and hardened all over, they can be used on flat surfaces, straight edges, shoulders, grooves, studs, dowels, centre points and scribed lines. To locate an edge first secure the finder in a collet or chuck, the work table is then traversed to cause the rotating edge finder to make contact with the workpiece. (fig 1). Upon touching the workpiece the edge finder's contact point will be forced into running concentrically with the body (fig 2). Any further movement to "off-centre" will cause a distinct wobble. At this point, the distance from the work edge to the centre of the finder is equal tohalf the diameter of the contact point. Datum lines and centre points are located using the combination edge and centre finder (fig 3). This has a cone shaped contact point which is lowered into position barely touching the workpiece at the point you wish to measure. The finder is made to run concentrically using a steel rule or straight edge (fig 4). UK supply of quality centre finders by Kennedy, buy online with confidence at best discount price and fast shipping. Manufacturer product ID KEN-518-1410K.

More Details : click here

SEARCH this site : click here